Electronic glass laser cutting machine is a commonly used processing equipment in the field of electronic glass, but it inevitably encounters some headache problems in daily work, especially the abnormal reset of the laser cutting machine. This is also a question that everyone is concerned about. In such a situation, what should we do? Shanghai Zhikaijie teaches you how to solve this problem!
Since the use of electronic glass laser cutting machines, there have been many precautions that need to be taken. Electronic glass laser cutting machines not only require us to understand the process of use, but also require us to have a certain understanding of the technology used. Electronic glass laser cutting machines often encounter problems with engraving and initialization, and here we need to correct the data to solve the problem.
Laser cutting machine engraving, initialization incorrect, data sent (corrected); Reverse the operation sequence (re-enter); Static interference (check if the ground wire has fallen off); Clean the misalignment and non closure of the hook edges, and check if the software parameter settings are correct (reset); Computer system error (reinstalling operating system and software); Check whether the tension of the left and right belts is consistent or whether the rear belt is too loose (belt tightening); Check whether the belt or synchronous wheel slips or jumps (tighten the synchronous wheel or belt); Check if the crossbeam is parallel (readjust the left and right belts).
There are several reasons for the abnormal reset of the laser cutting machine:
1. The X-axis and Y-axis of the laser cutting machine move in opposite directions and collide with the side end. This phenomenon requires checking whether the motherboard parameters are incorrect and stopping the machine to check if there are any issues with the motherboard parameter settings.
2. The control panel of the laser cutting machine displays normally, with the X-axis and Y-axis not moving. You can try unplugging the sensor terminals of the motherboard to see if the machine is moving. In this case, you need to consider replacing the sensor.
3. The crossbeam reset is normal, but the X-axis of the laser cutting machine cannot be reset. It is possible that the motor wire or shaft is broken, and this phenomenon requires replacing the motor wire or small motor.
4. When resetting, the direction is correct, but when it reaches the vertex, the X-axis or Y-axis cannot stop (check the motherboard parameters first). If it is correct, check the motherboard or sensor and replace it to eliminate this phenomenon.
Is the reset of the electronic glass laser cutting machine abnormal? I believe everyone has already figured it out after reading the on-site introduction. Shanghai Zhikaijie Laser Technology Co., Ltd. has been committed to innovation for many years, continuously developing multiple equipment for various types of glass cutting and drilling. At present, Shanghai Zhikaijie has developed into the brand with the most complete product series and the widest range of applicable scenarios in the laser glass cutting machine industry. The products are widely used in car glass and car displays, fine processing of large-sized glass, 3C consumer electronics, display screen industry, semiconductor industry, photovoltaic glass drilling and other fields, and have been highly praised by customers. Interested friends can further understand and cooperate with us!
